Ford Falcon

1992 Ford Falcon Fuel System   

i have no power starting the fuel pump up. it's not priming as the power is completely dead. at the time the battery was fine, and all other systems was working fine too. the engine was winding over, but no petrol getting to the engine to run it..

wow 1992 ford falcon didnt think they still made these if you dont mind where about are you located as far as your problem check fuses and relays

i'm located in australia, nsw.. and no they don't actually make it anymore lol.. i did check fuses, and changed the relays, and still no power to the pump itself..

are u getting power to the relay

my understanding is the relay's are clicking.. i replaced them, but i'll get that checked out properly.

if it isn't the relays, what else could be stopping power to the pump? would one of the sensors be doing that?

no sensor willnot but bad or corroded wiring will or fuel pump can be just plain faulty

we tested the wire on the engine side of the pump. there was no power getting to the pump at all. wiring could be it and that's scary lol..

what about the computer management system? could that be playing up?

no computer really doesnt have anything to do with fuel pump did you check power at relay with key on if so check the ground there too.

1988 Ford Falcon Electrical / Lighting Systems Upgrade  

i have a xf ute, i'm trying to install a ltd instrument cluster, however the annunciator lights work but i can't get the gauges to illuminate, is there something i have to change for this to work?

the instrument cluster must be grounded for the lights to operate there is only one switch leg to the lights plus a ground

1964 Ford Falcon Electrical / Lighting Systems Stalling Happens always 

I have a 1964 Ford Futura conv. 6 cyl. The voltage regulator is bad and it's not holding the charge. I've purchased another one but it look different then the first and the connections are labeled differently. I have a photo of the new and old that I could email if that would be helpful.

Send pictures, I own a 65 Galaxy and have a factory shop manual.
Bruce

[redacted]

still require help?

1964 Ford Falcon Drive Train / Driveline   

I am building a 1988 302 HO with 351w heads with roller rockers and cam and edlebrock intake with holley 650 with timing gear ( not chain )and I need all the torque specs for the entire motor. cam,crank, heads, intake etc. and tightening patern

Copy and paste the following link into your address bar-

http://www1.autozone.com/az/cds/en_us/[redacted] d/80/11/35/7d/[redacted] 357d/repairInfoPages.htm

The link will take you to a repair guide that should cover your engine.